How to select a roller chain for an industrial drive: ISO 606 pitch and series, simplex, duplex or triplex strands, sprocket tooth count, lubrication regime and when elongation means replacement.
Bevel Gears for Right-Angle Drives: Ratio, Backlash and Mounting Tolerance
How to choose and mount straight bevel gears for right-angle drives: ratio and module, backlash, mounting distance, contact pattern and the bearings that hold the gears in place.
Taper Lock V-Belt Pulleys: Matching Groove Profile, Bush Size and Shaft Bore in One Order
How to read taper bush V-belt pulley designations and match groove profile, datum diameter, groove count, bush size and bore in a single correct order.
SPZ, SPA, SPB and SPC Wedge Belts vs Classic Z, A, B and C Sections: Reading the Profile Before You Reorder
How to tell SPZ, SPA, SPB and SPC wedge belts from classic Z, A, B and C V-belts, read length codes correctly and avoid wrong reorders on industrial drives.
Schaeffler Nine-Month 2026 Preliminary Figures: What They Signal for FAG and INA Supply in Europe
Schaeffler’s preliminary nine-month 2026 figures show a stable, profitable bearings division behind the E-Mobility losses. What it means for FAG and INA buyers in Europe.
SKF Q3 2026: Better Margins and Selective Demand — What It Means for European Bearing Buyers
SKF lifted its adjusted margin to 16.3% in Q3 2026 while Europe stayed flat. What the results, the Vertevo spin-off and the savings plan mean for bearing buyers.
Simplex, Duplex and Triplex Sprockets: Matching Platewheels to Chain Pitch
How ISO 606 B-series codes, inner width, transverse pitch and tooth count determine the right simplex, duplex or triplex sprocket, and when to add strands instead of moving to a larger pitch.
Taper Lock Bushes Explained: Sizing, Keyways and the Torque Rating Table
What the four digits on a taper lock bush mean, how bore ranges and keyways work in metric and imperial, which screw torques to use and how to read the torque rating table.
Spur Gears With Hub vs Without Hub: Choosing the Right Mount for Your Drive
Hubbed spur gears and hubless plate gears share the same teeth but not the same shaft connection. How module, keyway, face width and locking elements decide which mount suits your drive.
Chain or belt on a conveyor drive: the maintenance cost nobody puts in the comparison
Elongation, lubrication reach, failure mode and washdown decide the real cost of a conveyor drive. A practical comparison of chain against belt over ten years.









