How V-ring axial seals work, when they beat or complement a radial shaft seal against splash and dust, and how to size, position and maintain them on real machines.
SKF Shaft Seals on the Shelf: Reading HMS5, HMSA10 and CRW1 Designations Against CORTECO Equivalents
How to read SKF HMS5, HMSA10 and CRW1 radial shaft seal designations, how they map to DIN 3760 types and CORTECO BA, BASL and B1 equivalents, and what to check before swapping.
Paper Machine Dryer Section Bearings: Heat, C3 vs C4 Clearance and Circulating Oil
Why dryer cylinder bearings on paper machines run hot, when C4 clearance beats C3, how the locating and floating sides work and what circulating oil must achieve.
W33 Lubrication Groove and Holes: Getting Grease to the Centre of a Spherical Roller Bearing
What the W33 groove and three holes in a spherical roller bearing outer ring actually do, how much grease to pump through them and the mistakes that starve the centre.
NBR, HNBR or FKM Rotary Shaft Seals: Choosing the Lip Elastomer by Temperature, Speed and Fluid
How to choose NBR, HNBR or FKM rotary shaft seals by lip temperature, sliding speed and fluid compatibility, with practical rules for ordering the right compound.
Rubber-Covered vs Metal-Cased Rotary Shaft Seals: Choosing DIN 3760 Type A, B or C for the Housing Bore
DIN 3760 Type A, B and C shaft seals differ at the outside diameter. How bore material, finish and installation decide between rubber-covered and metal-cased seals.
Relubrication intervals calculated for the duty you actually run, not the chart
Chart intervals assume seventy degrees, a horizontal shaft and light load. The correction factors that turn them into a schedule that prevents failures.
O-ring compound selection for hydraulics: NBR, FKM, EPDM and the traps
The fluid decides the compound and nothing else does. NBR ceilings, FKM blind spots, the EPDM oil trap, extrusion, compression set and reading a failed ring.
The gearbox output shaft that keeps weeping: single lip, double lip or PTFE
Compound before geometry, breather before seal, shaft groove before either. A working method for specifying rotary shaft seals on a difficult gearbox position.
When to reach for an SKF hybrid bearing (and when it’s overkill for the application)
When to reach for SKF hybrid bearings (and when it’s overkill) — application decision framework for European industrial specification.









